BLADE TMC KIT for the Losi Micro Crawler
Install Front shock mount/cross brace as shown below
Install Rear Shock mount/cross brace just as you did the front
Next get your 2 roll bars windshield, and rear window frame
Install as shown below
You Will need to Cut the 90 degree cross brace from your Losi Micro Crawler into
2 cross braces, you will use the half in the picture with the X on it for the rear Cross brace.
Install Rear cross brace as shown below make sure to slide it into the back of the roll
bars as shown
Install Front Cross brace as shown below using the other cross brace that was cut from
the original 90 degree brace from your Losi Micro Crawler
This is the frame built and ready for the axles, tranny ect.
You will need to remove the Case around you ESC/Receiver from your Losi Micro Crawler
and wrap it in Black tape or something Similar for protection.
Install Upper links in bottom hole on chassis sides.
Install Shock mount cross braces in the center slit with the 5mm Philip screws.
Install upper shocks in top holes on shock mount cross braces.
Here the upper shocks are mounted in the upper holes of the shock mount cross brace.
Mount the Rear shocks just like you did the front.
Reinstall the Roll cage as shown in the beginning of this build info.
The body panels can be painted with lexan paint and can be glued with 5 minute epoxy.
These are basic build instructions for the Blade TMC chassis using the stock links, there is
alot of different setup options play around with it and enjoy.
www.crawlerx.net